Ribbon Fiber Cable Assemblies
Standard and Custom Ribbon Fiber Cables, Bulk Ribbon Fiber
Pricing and Free Samples
Our company manufactures ribbon fiber cables, such as standard and custom ribbon fiber assemblies with a large diversity of connector types for both multimode and single mode applications.
|
Full In House Capabilities in the USA
|
|
Fiber Cable Assembly Design
Fiber Cable Assembly Engineering
Fiber Cable Assembly Prototypes
Custom Fiber Cable Assemblies
Specialty Fiber Optics
|
|
100% Tested
|
|
We serve commercial, industrial and military markets with built to specs and custom built ribbon fiber optic cables designed, engineered and manufactured in the USA. As a Corning Gold Assembly House we pride ourselves with quality fiber optic assemblies which are 100% tested. Contact us today for:
62.5 µm Ribbon Fiber Cable Assemblies
50 µm Ribbon Fiber Cable Assemblies
LANscape® Pretium® 300 Ribbon Fiber Cable Assemblies
Single-Mode Ribbon Fiber Cable Assemblies
|
Ribbon Riser
Ribbon Interconnect Riser (2, 4 and 12 fiber)
FREEDM Ribbon Riser Cable for Indoor/Outdoor Applications
FREEDM Interlocking Armored Ribbon Fiber Cable for Indoor/Outdoor Applications
Ribbon Plenum
Ribbon Interconnect Plenum (2, 4 and 12 fiber)
|
Multimode Connectors for Ribbon Fiber Assemblies
SC PC simplex
SC PC duplex
LC PC simplex*
LC PC duplex*
FC PC simplex
ST® Compatible PC
|
Single-mode Connectors for Ribbon Fiber Assemblies
SC simplex UPC, SC simplex APC
SC duplex UPC
LC simplex UPC, LC simplex APC*
LC duplex UPC
LC 90º boot clip UPC*
FC simplex UPC, FC simplex APC
ST Compatible UPC
|
|
Contact us Today for Quick Quotes, more Info and to order Ribbon Fiber and Assemblies
|
|
The following are related: Corning ribbon fiber, ribbon fiber optic cable, ribbon fiber, ribbon fiber assembly
About Gel Free SST Ribbon Fiber Cables for Outside Plant Applications
SST-Ribbon Cables are designed primarily for outside plant environments and campus backbone applications.
In single-tube ribbon cables, several fibers (typically 12) are fabricated into a ribbon. The fibers are held together in an acrylate matrix, which provides excellent mechanical protection. Ribbons are stacked, and the stack is rotationally stranded into a central buffer tube. This enhances the tensile and bending performance of the cable. Finally, dielectric strength members with waterblocking capability are placed alongside the central buffer tube to provide tensile strength.
SST-Ribbon Cables differ from loose tube cables in that ribbon stacks offer exceptional packing
density. In higher fiber counts, SST-Ribbon Cables save valuable duct space over loose tube cables. Further, SST Ribbon Cables enable use of Unicam MTP Connectors or mass fusion splicing to terminate several fibers in a single operation, often reducing the overall cost of termination.
Gel-free waterblocking materials protect the interstitial areas of the buffer tube against water ingress. These materials incorporate superabsorbent polymers that swell on contact with water to block ingress of moisture. The materials reactivate indefinitely over dry/wet cycles so that cables will remain protected even from undetected holes or tears.
Outside plant SST Ribbon Cables are jacketed with an MDPE outer sheath. This material provides excellent flexibility and a low coefficient of friction for easy installation. Additionally, the MDPE sheath contains carbon black to provide superior UV resistance over the life of the cable. Indoor ribbon cables are jacketed with specialty compounds which facilitate compliance to the flame-retardant and smoke-generation requirements of the intended applications.
|
